Yes, we do sell replacement parts for park benches, including slats and bolts. If your bench has cracked wooden slats, rusted bolts, or missing fasteners, you usually don’t need to replace the whole bench. Most park benches are made to be repaired, and replacement slats and bolts are the two parts people ask about most often.
For slats, we carry several common materials and sizes: kiln-dried hardwood, pressure-treated pine, recycled plastic lumber, and powder-coated aluminum or steel slats. The right choice depends on your climate and how the bench is used. Wood slats give a classic park bench look, but they need periodic sealing. Recycled plastic and coated metal slats tend to last longer outdoors and need very little maintenance. When measuring for replacement slats, don’t just measure the old board end to end. Also check the center-to-center distance of the mounting holes and note whether the holes are countersunk or flat.
For bolts and hardware, we stock carriage bolts, hex-head bolts, stainless steel screws, nylon lock nuts, flat washers, and bench hardware kits. For outdoor park benches, we recommend stainless steel or hot-dip galvanized fasteners. Zinc-plated bolts are cheaper, but they can corrode faster in wet or coastal environments. If your old bolts are seized, penetrating oil and a breaker bar usually help. Soaking the hardware overnight can save you from drilling out broken bolts.
We also keep replacement armrest brackets, center supports, and cast iron end frames for select bench models. If you only need a few slats or bolts, we sell them individually. If you want to refresh the whole bench, hardware kits and pre-cut slat sets are available at a lower per-piece price.
Before ordering, try to confirm the bench manufacturer or at least take photos of the frame, the old slats, and one bolt with a ruler next to it. That makes it much easier to match thread pitch, length, and slat profile. If you’re not sure what you need, send those photos through our contact form and we’ll help you identify the correct parts.
In most cases, replacing slats and bolts takes less than an hour with basic tools. Remove the old hardware, clean the mounting points, set the new slats in place, and tighten the bolts evenly so the frame doesn’t twist. If you’re using wood slats, pre-drill the bolt holes slightly larger than the shank to prevent splitting. For metal or recycled plastic slats, follow the manufacturer’s torque recommendations so you don’t crush the material.
So yes — if you’re looking for replacement park bench slats, bolts, or related hardware, we have them in stock and can ship individual parts or full repair kits. Even if your bench is an older model, there’s a good chance we can match it.