No, our street benches do not have sharp edges that would create an obvious safety hazard for children. We treat edge finishing as a core part of the design, not an afterthought. Every metal slat, armrest end, frame tube, and welded joint is deburred, ground smooth, rounded, or capped before the bench leaves our facility. That means no raw cut metal, no exposed sharp corners, and no protruding bolt threads for little hands to catch on.
For steel and aluminum benches, we round the ends of seat slats and armrests, and we grind welded areas flush so there are no jagged seams. Fasteners are either recessed into the frame or covered with tamper-resistant caps. This keeps the surface smooth to the touch and reduces the chance of cuts, scrapes, or snagged clothing.
For wood and recycled plastic benches, we route or sand the top edges and front corners to a soft radius. We pay special attention to the seat edges where children are most likely to bump their heads or grip with their fingers. The finish is smooth enough to run a hand across without catching.
We also check our benches against common public seating safety expectations. While no outdoor furniture can promise zero risk in every possible situation, our goal is to remove the obvious hazards. If you are placing benches near a playground, school, daycare, or family park, we recommend choosing models with fully rounded armrests, closed or narrow backrest gaps, and no open tube ends. Those details make a real difference for child safety.
The short answer is no: our street benches do not have sharp edges. The longer answer is that we design them that way on purpose. If you need help selecting a child-safe bench for a specific location, just reach out and we can point you to the best options.