For a street bench on a concrete sidewalk, I’d use stainless steel wedge anchors. My default size is 1/2-inch diameter by 4-1/2 inches long, assuming the sidewalk slab is at least 4 inches thick and the bench base plate is relatively thin. If the bench is extra heavy, located in a high-traffic area, or prone to rocking and vandalism, I’d step up to 5/8-inch diameter anchors.
Why wedge anchors? They’re strong in solid concrete, handle shear and pull-out loads well, and are straightforward to install with a hammer drill. A street bench gets a lot of lateral force when people sit, stand, and shift around, so you need something that won’t loosen or pull out. I would not use plastic anchors, Tapcons, or basic expansion shields for this. They’re either too weak or too likely to degrade outdoors. Sleeve anchors can work, but wedge anchors are a better all-around choice in solid sidewalk concrete.
For material, go with stainless steel if you can. 304 stainless is fine for most climates, but 316 stainless is the better call near the coast or anywhere de-icing salts are common. Hot-dipped galvanized wedge anchors are a decent budget alternative, but avoid electro-galvanized or zinc-plated anchors because they rust quickly outdoors.
Make sure you embed the anchor deep enough. For a 1/2-inch wedge anchor, you typically want at least 2-1/4 to 2-3/4 inches of embedment into the concrete. A 4-1/2-inch-long anchor gives you enough room for the bench base plate, washer, nut, and proper embedment without punching through a 4-inch sidewalk. If your bench has a thicker base plate, use a longer anchor.
When you install them, use a hammer drill and a carbide-tipped masonry bit sized for the anchor, usually 1/2 inch. Drill the hole slightly deeper than the anchor will penetrate, then clean the dust out with a brush or air puffer. Set the anchor through the bench base plate, hammer it down until the nut and washer are snug against the base, and tighten it to the manufacturer’s recommended torque. Keep the anchors at least 2 to 3 inches away from the slab edge or control joints to avoid cracking the concrete. I’d also use stainless washers and nylon lock nuts or threadlocker to keep everything tight over time.
If the concrete is cracked, spalling, or you just want maximum holding power, epoxy-set stainless threaded rods are an excellent upgrade. But for most standard street benches on sound concrete sidewalks, stainless steel wedge anchors are the simple, reliable answer.