URBAN BENCHES

We are seasoned manufacturer emphasizing durability, design & core production

Home ・ About ・ Product ・ Q&A ・ Contact ・ Factory ・ Main

Common Problems and Effective Solutions for urban benches

Is the concrete on this urban bench dyed through the whole piece or just surface-coated?

Great question, and honestly, the answer depends on how the bench was manufactured. For most mass-produced urban concrete benches, the color is usually not dyed through the entire thickness. Instead, the concrete is either mixed with a pigment only in the outer layer, or more commonly, a colored surface coating is applied after the bench is cast. True through-body color — where the pigment is evenly distributed through every inch of the concrete mix — is more expensive and less common, though it does exist for high-end or custom pieces.

Here’s the practical giveaway: if you see a small chip, scratch, or worn edge, look closely. If the exposed material underneath is the same color as the surface, then the bench has through-body color or at least a very deep integral pigment. If the exposed concrete is plain gray or a different shade, then the color you see is just a surface coating. Surface coatings on urban benches are often acrylic stains, pigmented sealers, or epoxy paints. These can look great for a year or two, but they tend to wear off in high-traffic areas, especially along the seat edges and armrests.

Some manufacturers use a middle-ground method: a colored cementitious top layer, like a thin colored overlay applied to the face of the bench. That’s still technically a surface treatment, not through-body color, even though it’s thicker and more durable than paint. So unless the bench was specifically advertised as “integral color concrete” or “through-colored,” the safest bet is that it’s surface-coated.

If you want to test it without damaging the bench, look for a small existing chip or scratch near the bottom edge. You can also check the underside — many benches are left uncoated underneath, and if that area is plain gray, you’ve got your answer. For a new bench you’re considering buying, ask the supplier directly: “Is the pigment mixed into the full concrete batch, or is the color applied as a coating?” That one sentence will tell you exactly what you’re getting.

Relevant keywords:

If you have any different opinions or need to consult us further, please pay attention or send us an email. We will reply to each of you individually! Thank you for your support and trust!

Internal navigation on the site:Home About Product Question and Answer Contact

Copyright © 2013 - 2026 UrbanBenches.Com(HONGYI Factory). All rights reserved.