If you are tired of tire marks on the seat and the sound of a bike clattering across a public bench, the fix usually comes down to one principle: remove the smooth, continuous surface and straight approach that riders need.
Start with the bench itself. Add a center armrest or split the seating area into shorter sections. A full-length flat plank is basically an invitation, while a metal divider every 1.2 to 1.5 metres breaks the line and makes it almost impossible to ride along or pop off the end. If the bench already has armrests only at the sides, retrofitting a central rail or two can solve much of the problem without replacing the whole unit.
Next, look at the seat profile. Many modern anti-ramp bench designs use a curved or wavy top, rounded edges, or a slight downward slope toward the front. These shapes give bike tires no stable lip to launch from. Slats can also be rotated so they run front-to-back rather than side-to-side, which reduces the continuous edge a tire can roll up. If you are specifying new furniture, ask for individual seat pans or heavy cast-iron end frames that block entry from the sides.
Surface texture helps more than people expect. A high-friction coating, grit finish, or deeply grooved hardwood makes the surface unpleasant and unpredictable for bike tires while still being fine for sitting. Avoid smooth polished stone or slick metal on the top surface.
Then look at the surroundings. A bench placed directly in line with a long, straight path gives a rider speed and a clear target. Move the bench slightly off-axis, or place a planter, bollard, or low rail a metre or two in front of it. That forces a sharp turn or slows the approach. Low planting beds or a rough gravel strip around the bench also deter tricks without making the space feel defensive.
If you manage a public space, anchoring the bench properly matters too. Use security fixings and a heavier base so the bench cannot be dragged into a better position. A bench that is bolted down well is less likely to be repositioned to create a ramp.
Finally, pair physical changes with observation. Cameras or regular staff patrols may be needed in the first few weeks after installation because riders often test new furniture. Once the design no longer works for tricks, they usually move on.
The best approach is usually layered: a center armrest or dividers, a rounded or textured seat, and a small obstacle or offset in the surrounding space. You keep a comfortable place to sit, but take away the straight run-up, the stable lip, and the smooth landing that a bike rider needs.