URBAN BENCHES

We are seasoned manufacturer emphasizing durability, design & core production

Home ・ About ・ Product ・ Q&A ・ Contact ・ Factory ・ Main

Common Problems and Effective Solutions for urban benches

Can an urban bench be used as a planter box if I remove the seat slats?

Honestly, yes, you can absolutely use an urban bench as a planter box once you take off the seat slats. I have done this a couple of times with old slatted benches from city sidewalks and even a tired one from a park edge. The basic idea is simple: remove the horizontal wood or metal slats, keep the side and end frames, and line the open cavity with something that holds soil. But there are a few real-world things you need to watch, or you will end up with a rotting mess or a bench that collapses under wet soil weight.

First, check what the bench frame is made of. Most urban benches have cast iron or steel ends and wood slats on top. The ends are usually strong enough to act as the short walls of a planter, but the long sides might just be rails that the slats screwed into. If the long rails are thin metal or flimsy wood, you will need to reinforce them. I usually screw a couple of pressure-treated 2x4s horizontally along the inside of the long rails to create a solid rim. That also gives you something to attach a fabric grow bag or a custom wooden liner to.

Second, you need a liner. The original bench slats are not designed to hold soil directly because they have gaps and they rot fast when constantly wet. I recommend either a heavy-duty fabric planter bag that fits inside the frame, or building a simple box from cedar or plastic lumber that drops into the bench frame. Leave about half an inch of space between the liner and the metal frame so air can circulate. If you want a more rustic look, you can screw new boards tightly side by side along the inside to form the actual planter walls, but then drill drainage holes in the bottom board and lay a piece of landscape fabric over them.

Drainage is the thing most people forget. An urban bench has no bottom, so if you just fill the cavity with soil, water will pool against the frame and rust or rot it. Put a few inches of gravel or broken clay pot shards at the very bottom of the liner, or place the whole planter on small blocks so excess water can escape. I also like to set the bench frame on a couple of bricks so the bottom rails are not sitting in puddles. If the bench is going on a balcony or roof, put a saucer or waterproof tray underneath.

Soil weight is another big one. Wet potting mix can weigh over 40 pounds per cubic foot. A typical six-foot bench cavity holds about 3 to 5 cubic feet, so you might be dealing with 120 to 200 pounds of soil plus water. The original bench was built to hold maybe two or three people, around 400 to 600 pounds, but that load was spread across the slats and focused on the ends. Your planter load will push outward on the long sides, so do not skip the reinforcement. I usually add a cross brace or two near the bottom of the frame to keep the long sides from bowing outward. A simple threaded rod with washers and nuts through both sides works.

What can you grow in a bench planter? Shallow-rooted things do best because most bench frames give you only 8 to 12 inches of depth after you account for drainage. Lettuce, spinach, herbs like basil and parsley, strawberries, radishes, and small annual flowers all thrive. Tomatoes and peppers work if you choose compact or dwarf varieties and keep the soil consistently moist. I would avoid deep-rooted carrots or large shrubs.

One more tip: if the bench is metal and you live in a hot climate, the soil can heat up fast because the metal sides absorb sun. I usually line the inside of the metal frame with a thin sheet of foam insulation or even a few layers of cardboard before putting in the liner. It helps keep roots cooler and reduces moisture loss. In winter, if you live somewhere freezing, empty the soil or move the planter under cover because the freeze-thaw cycle can crack cast iron or split wood frames.

So yes, remove those slats, reinforce the frame, add a liner with drainage, and you have a unique street-style planter box that becomes a real conversation piece. Just do not skip the reinforcement or drainage, or the bench will fail sooner than you think. I have learned that the hard way with a rusted-out side rail after one rainy season. With a little prep, though, it is a rewarding weekend project that gives an old city bench a second life as a garden feature.

Relevant keywords:

If you have any different opinions or need to consult us further, please pay attention or send us an email. We will reply to each of you individually! Thank you for your support and trust!

Internal navigation on the site:Home About Product Question and Answer Contact

Copyright © 2013 - 2026 UrbanBenches.Com(HONGYI Factory). All rights reserved.